To
Release from Windows Boot Error 
Windows boot error
takes the happiness away because the computer reaches
such a state where we cannot do anything thing apart
from tuning it on and off. It happens due to the hard
drive crash. Most of the time, we see a black or a blue
screen with a stop error. Windows boot error
is not only about hard drive crash but the system which
is not able to load the operating system. However, we
can release the computer from these kinds of error messages.
To start the troubleshooting, first we need to settle
on the BIOS. There, the settings should be not be configured
under UDMA modes. After this we need to re-boot the
system and need to enter the BIOS by pressing “F10”
key. Then we need to load the "fail-safe"
default settings. Again we need to reboot the system
and windows boot error should be vanished.
If we still face issues, it is better if we check the
IDE cables. It has happened that when we inter-change
the hard drives, by mistake we attached wrong IDE cables.
That is why we are getting windows boot error.
Like wise, if we come across any error related to the
UDMA hard-disk controller then we can fix it with the
help of a standard 40-wire connector cable. This could
be the correct IDE cables for the hard-disk drives.
However, if we still see same issue then we may start
the computer from the windows installation CD. For that
we need to put the CD in the computer and restart the
computer. We need to "Press any key to boot from
CD". Then need to press "R" to use the
Recovery Console. At last we need to restart and the
windows boot error no more exists in
the system.
|
